[Coco] For sale? (Another SDC Case Attempt)

[Christopher Barnett Fox]

Tim,

I¹d be very interested in two completed cases, clear/translucent doesn¹t
matter.

Thanks for taking the time to design and offer these for sale to the group!

Christopher


On 20141107, 10:38, "tim lindner" <tlindner at macmess.org> wrote:

>Thanks everyone for the kind words. I went and bought a bunch of
>scraps from tap plastic. Some clear, some translucent. For $14 I have
>the material to cut about 15 sets. For the clear plastic the engraved
>type is nice. But for translucent I would do a sticker as seen in my
>video.
>
>So a complete set would be:
>
>Top and bottom plate.
>3 x 0.5 inch #6 machine screws
>3 x 0.25 inch #6 machine screws
>1 x stand off 5/8 inch tall, 0.25 OD
>2 x stand off 1/8 inch tall, 0.25 OD
>2 x stand off 9/16 inch tall, 0.25 OD
>
>The stand offs might need some sanding down if the plastic is thicker
>than 3mm.
>
>This would be the assembly instructions:
>
>1. The holes in the plates are all pilot holes, drill them all to size
>to fit the screws.
>2. Using a 1/4 inch drill bit, flare the outside of each hole so the
>screw sits flush.
>3. Attach the 5/8 inch tall stand off to the top plate in the center
>hole with a 1/4 inch screw.
>4. Attach the 2, 9/16 inch tall stand offs to the top plate in the two
>end holes with 1/4 inch screws.
>5. Attach the 2, 1/8 inch tall stands offs in the bottom plate in the
>two end holes with 1/2 inch screws.
>6. Place the PCB on top of the bottom plate, aligning the two end holes.
>7. Bring the top plate together with the bottom plate, aligning center
>stand off and the two end screws.
>8. Screw the two end bottom plate screws to the two top plate stand offs.
>9. Screw the center stand off to the bottom plate with a 1/2 inch screw.
>
>So...
>
>Would you want clear (like the pictures I posted yesterday) or
>translucent (like the video I posted this weekend)?
>How many would want completed cases, with plates and all the hardware,
>drilling and attaching?
>How many would want just the plates and hardware?
>How many would want just the plates?
>
>Let me know and I'll work up some prices.
>
>-- 
>--
>tim lindner
>
>-- 
>Coco mailing list
>Coco at maltedmedia.com
>https://pairlist5.pair.net/mailman/listinfo/coco