[Coco] For sale? (Another SDC Case Attempt)

[tonym]

if it's possible, 3 cases, ready-to-use.
I have enough stuff in my garage on waiting list "to-be-completed."

Short of that, i'll still take 3 :)

Tony


---- Original Message ----
From: "tim lindner" <tlindner at macmess.org>
Sent: 11/7/2014 10:38:17 AM
To: "CoCoList for Color Computer Enthusiasts" <coco at maltedmedia.com>
Subject: [Coco] For sale? (Another SDC Case Attempt)

Thanks everyone for the kind words. I went and bought a bunch of
scraps from tap plastic. Some clear, some translucent. For $14 I have
the material to cut about 15 sets. For the clear plastic the engraved
type is nice. But for translucent I would do a sticker as seen in my
video.

So a complete set would be:

Top and bottom plate.
3 x 0.5 inch #6 machine screws
3 x 0.25 inch #6 machine screws
1 x stand off 5/8 inch tall, 0.25 OD
2 x stand off 1/8 inch tall, 0.25 OD
2 x stand off 9/16 inch tall, 0.25 OD

The stand offs might need some sanding down if the plastic is thicker than 3mm.

This would be the assembly instructions:

1. The holes in the plates are all pilot holes, drill them all to size
to fit the screws.
2. Using a 1/4 inch drill bit, flare the outside of each hole so the
screw sits flush.
3. Attach the 5/8 inch tall stand off to the top plate in the center
hole with a 1/4 inch screw.
4. Attach the 2, 9/16 inch tall stand offs to the top plate in the two
end holes with 1/4 inch screws.
5. Attach the 2, 1/8 inch tall stands offs in the bottom plate in the
two end holes with 1/2 inch screws.
6. Place the PCB on top of the bottom plate, aligning the two end holes.
7. Bring the top plate together with the bottom plate, aligning center
stand off and the two end screws.
8. Screw the two end bottom plate screws to the two top plate stand offs.
9. Screw the center stand off to the bottom plate with a 1/2 inch screw.

So...

Would you want clear (like the pictures I posted yesterday) or
translucent (like the video I posted this weekend)?
How many would want completed cases, with plates and all the hardware,
drilling and attaching?
How many would want just the plates and hardware?
How many would want just the plates?

Let me know and I'll work up some prices.

-- 
--
tim lindner

-- 
Coco mailing list
Coco at maltedmedia.com
https://pairlist5.pair.net/mailman/listinfo/coco