[Coco] Run of RGB2VGA boards

[John B]

Ed,

I received my board today and it looks great.  Even better than the
pictures.  Fantastic job.  I just wanted to publicly thank you for your
contributions to the community and the stellar work you do.

John

On Sat, Sep 12, 2015 at 11:38 AM, Zippster <zippster278 at gmail.com> wrote:

> Super easy, there is ground plane right next to Pin 10.  Just scrape away
> a little solder mask on the bottom of the board next to the pin and create
> a
> solder bridge.
>
> Detail of connector area...
> <https://drive.google.com/open?id=0B1sgl615FlGnODZOSVJnVjZLbGs <
> https://drive.google.com/open?id=0B1sgl615FlGnODZOSVJnVjZLbGs>>
>
> The red traces for the sync lines are on the top layer of the board, so
> you’re
> clear on the bottom (blue).
>
> - Ed
>
>
> > On Sep 12, 2015, at 10:31 AM, Brett Gordon <beretta42 at gmail.com> wrote:
> >
> > ok... Im guessing it wouldn't be hard for a guy with a soldering iron to
> > connect pin 10 to ground?
> > On Sep 12, 2015 11:26 AM, "Zippster" <zippster278 at gmail.com> wrote:
> >
> >> No, only R, G, B, HSYNC, and VSYNC are brought through the connector to
> >> the board.
> >>
> >> - Ed
> >>
> >>
> >>> On Sep 11, 2015, at 11:47 PM, Brett Gordon <beretta42 at gmail.com>
> wrote:
> >>>
> >>> Does the RGB2VGA board support the coco's monitor detect line?
> >>>
> >>> --
> >>> Coco mailing list
> >>> Coco at maltedmedia.com
> >>> https://pairlist5.pair.net/mailman/listinfo/coco
> >>
> >>
> >> --
> >> Coco mailing list
> >> Coco at maltedmedia.com
> >> https://pairlist5.pair.net/mailman/listinfo/coco
> >>
> >
> > --
> > Coco mailing list
> > Coco at maltedmedia.com
> > https://pairlist5.pair.net/mailman/listinfo/coco
>
>
> --
> Coco mailing list
> Coco at maltedmedia.com
> https://pairlist5.pair.net/mailman/listinfo/coco
>