[Coco] DE-0 Nano Successfully Programmed!

[Steve Batson]

Good :)

On Jun 4, 2015, at 8:01 PM, Kip Koon <computerdoc at sc.rr.com> wrote:

> Hi Steve,
> Absolutely!  I programmed mine without the RGB2VGA board attached.  With the short 1" cables I was using, as soon as I plugged in the monitor cable to the VGAOUT connector, the power light on the DE-0 Nano turned off!  Ouch!!!  Fortunately, no damage was done and I eventually programmed the rgb2vga.jic file using the jtag option into my DE-0 Nano just fine.  I found out from John Mark that all the pins were switched - 1 to 2 and 2 to 1 onward to 39 & 40 instead of being 1 to 1 and so on.  
> 
> Kip Koon
> computerdoc at sc.rr.com
> http://www.cocopedia.com/wiki/index.php/Kip_Koon
> 
> 
> 
>> -----Original Message-----
>> From: Coco [mailto:coco-bounces at maltedmedia.com] On Behalf Of Steve Batson
>> Sent: Thursday, June 04, 2015 9:37 AM
>> To: CoCoList for Color Computer Enthusiasts
>> Subject: Re: [Coco] DE-0 Nano Successfully Programmed!
>> 
>> I'm assuming the board can be programmed without the RGB2VGA card attached...My DE-0 Nano should be her Friday. My plan is to
>> program the board with Luis's code and have it ready to go when Kip's card arrives so I can test right away. Once tested and working,
>> my next task will be to find an enclosure to put it in.
>> 
>> 
>> On Jun 4, 2015, at 5:29 AM, Steve Batson <steve at batsonphotography.com> wrote:
>> 
>>> And that's what is expect if all is done right.
>>> 
>>> Kip, I'd rather see your known working procedure than a translated procedure that had errors.
>>> 
>>> Steve Batson
>>> Batson Photography
>>> "Today's Special Moments, Tomorrow's Priceless Treasures"
>>> 
>>> Website: http://www.batsonphotography.com
>>> Blog: http://www.batsonphotography.com/blog
>>> Our Free Photography Site and Forum: http://www.digitalphotographerzone.com
>>> 
>>>> On Jun 4, 2015, at 4:39 AM, Steven Hirsch <snhirsch at gmail.com> wrote:
>>>> 
>>>>> On Wed, 3 Jun 2015, Steve Batson wrote:
>>>>> 
>>>>> This should be helpful. A little worrisome that there are so many errors that occur. If you have an additional tips from your
>> experience, would be nice to see them too.
>>>> 
>>>> FWIW, I have yet to see any sort of error during either compilation or programming.
>>>> 
>>>> --
>>>> 
>>>> --
>>>> Coco mailing list
>>>> Coco at maltedmedia.com
>>>> https://pairlist5.pair.net/mailman/listinfo/coco
>>> 
>>> 
>>> --
>>> Coco mailing list
>>> Coco at maltedmedia.com
>>> https://pairlist5.pair.net/mailman/listinfo/coco
>> 
>> 
>> 
>> --
>> Coco mailing list
>> Coco at maltedmedia.com
>> https://pairlist5.pair.net/mailman/listinfo/coco
> 
> 
> -- 
> Coco mailing list
> Coco at maltedmedia.com
> https://pairlist5.pair.net/mailman/listinfo/coco