[Coco] Got the SDC

[Bill Loguidice]

One thing that some of the other communities have been experimenting with
is 3D printing cartridge shells, both long and short. Apparently with the
right mix of equipment, the results are extremely durable and a great fit.
Anyone here have the capability to make such a shell for the SDC based off
the FD cart?

-Bill

===================================================
Bill Loguidice, Managing Director; Armchair Arcade,
Inc.<http://www.armchairarcade.com>
===================================================
Authored Books<http://www.amazon.com/Bill-Loguidice/e/B001U7W3YS/ref=ntt_dp_epwbk_1>and
Film <http://www.armchairarcade.com/film>; About me and other ways to get
in touch <http://about.me/billloguidice>
===================================================


On Tue, Feb 18, 2014 at 12:12 PM, <billg999 at cs.uofs.edu> wrote:

> > Finally is crossed the  twilight zone. I couldn't test it completely
> > but it loaded a disk and played well.
> >
> > The board is very well built.
> >
>
> I got mine yesterday, as well, but didn't have time to play with it.
> have started looking for a case.  It's too big for regular cartridge
> and too small for one of the old OWLware carts.  Can't see scrapping a
> FD cart as I still use all of them.  What a dilemma.  :-)
>
> bill
>
>
>
> --
> Coco mailing list
> Coco at maltedmedia.com
> http://five.pairlist.net/mailman/listinfo/coco
>