[Coco] TC^3 SCSI Controller

jimcox at miba51.com jimcox at miba51.com
Tue Jun 22 10:42:04 EDT 2004

Hi Boisy:

I don't have a TC^3 interface yet, and may hold off 
getting one since I seem to remember that you and Mark are 
making a newer interface(?) and from what is posted on the 
Cloud-9 site, the Super Board will have one.

I have both a Ken-Ton and Disto SCSI interface and I 
believe that they are for SCSI 2.  According to most sites 
that I have research SCSI on, this is actually what most 
people refer to when they refer to SCSI.  Is this right or 


On Mon, 21 Jun 2004 18:45:11 -0500
  "Boisy G. Pitre" <boisy at boisypitre.com> wrote:
>The TC^3 interface itself supports a 50 pin SCSI drive. 
> If the drives you are receiving have 50 pin connectors 
>on them, then they will in all likely-hood work with the 
>I have run across some SCSI-2 drives that aren't 
>compatible with the current SCSI driver set.  These 
>drives tend to utilize the message phase to send out SDTR 
>messages that the driver doesn't expect.  Usually, drives 
>can be configured not to do this, but not all can.
>Do you have a TC^3 controller, or will you be buying one?
>On Jun 21, 2004, at 6:19 PM, <jimcox at miba51.com> wrote:
>> Is anyone out there using one of these, and if so, what 
>>type of SCSI 
>> (SCSI 1, SCSI 2, ect..) does it work with. From what I 
>>can tell of the 
>> connector, it uses SCSI 2, but just wanted to make sure 
>>because some 
>> one is offering some free SCSI drives to me.
>> Jim
>> -- 
>> Coco mailing list
>> Coco at maltedmedia.com
>> http://five.pairlist.net/mailman/listinfo/coco
>Coco mailing list
>Coco at maltedmedia.com

More information about the Coco mailing list