[Coco] Modern monitors that work on CoCo 3 and MM/1
Christopher R. Hawks
chawks at dls.net
Wed Mar 12 20:16:04 EDT 2025
On Wed, 12 Mar 2025 18:55:46 -0500
Robert Emery via Coco <coco at maltedmedia.com> wrote:
> Try the aspect ratio settings, and some monitors have a "just scan"
> (advanced) setting that might help.
>
> On Wed, Mar 12, 2025, 6:36 PM Christopher R. Hawks via Coco <
> coco at maltedmedia.com> wrote:
>
> > On Thu, 6 Mar 2025 20:57:31 -0600
> > Allen Huffman via Coco <coco at maltedmedia.com> wrote:
> >
> > > > On Mar 6, 2025, at 8:48 PM, Christopher R. Hawks via Coco
> > > > <coco at maltedmedia.com> wrote:
> > > >
> > > > AND freesync ONLY works with HDMI and Display Ports! So the
> > > > 'freesync' part is moot for the CoCo RGB. G-Sync is only on
> > > > Display Ports (v1.2a).
> > > >
> > > > What matters is if the VGA port will take a 15KHz signal. I
> > > > have a couple that do and one on the way that will. None of
> > > > them are freesync or G-Sync. Most of the previous monitors only
> > > > sync down to 30 KHz.
> > > >
> > > > Hopefully, the 'sync's will guarantee that ALL inputs can
> > > > sync to 15 KHz...
> > >
> > >
> > > The plot thickens. Thank you for shedding light on this!
> > >
> > > --
> > > Allen Huffman - PO Box 7634 - Urbandale IA 50323 - 515-999-0227
> > > (vmail/TXT
> > > only) http://www.subethasoftware.com -
> > https://www.facebook.com/subethasoftware
> > >
> > >
> > >
> >
> > Took delivery of the new monitor yesterday. It does work with
> > the 15KHz signal, BUT!
> >
> > The displays from BASIC (24 lines, WIDTH 80) and NitrOS9 (24
> > lines) are a bit low on the screen. EOU (25 lines) is so low on the
> > screen that half of the last line is OFF THE SCREEN.
> >
> > Is EOU mucking with something else?? Vertical for BASIC and
> > NitrOS9 start and end at the same place on the screen, but, EOU
> > starts 2 lines higher and the bottom half of line 25 is off screen.
> >
> > The vertical position setting on the monitor only moves the
> > display a few pixels.
> >
> > Christopher R. Hawks
Aspect Ratio is greyed out for VGA. In fact, all my monitors/TVs
either don't show it or grey it out for VGA inputs.
Christopher R. Hawks
HAWKSoft
--
I usually find "alt" + "ctrl" + "clawhammer" to work in those
situations. I hope to buy an abacus soon, though.
-- Panther Wyvern
----------------------------------------
\ ^__^
\ (oo)\_______
(__)\ )\/\
||----w |
|| ||
More information about the Coco
mailing list