[Coco] 3D printer

[Glen Hewlett]

Hi Reitveld

I agree with Mark it’s a nice case that let’s you click on the CoCO SDC button too.  

But for your first few prints I would try to keep it simple and do some calibration prints to get to know the limits of your printer and the software you use with it.  After a while if you do a lot of printing you might want to upgrade your slicing software to "Simplify 3D” the software is a little pricey but when it’s set up properly for your printer you can be confident that what is sent to your 3D printer will come out as planned.  I’ve gone through a lot of slicing software and they all have good and bad things, but once I broke down and purchased Simplfy 3D I never looked back.

Enjoy the printer,
Glen

> On Jul 11, 2017, at 6:24 PM, Mark Ormond <markormond at mtxsystems.com> wrote:
> 
> https://www.thingiverse.com/thing:1492619
> 
> 
> CoCo SDC Cartridge Case
> by zoharel, published Apr 15, 2016
> 
> 
> I love this case for my sdc.
> 
> 
> 
> 
> -----Original Message-----
> From: Coco [mailto:coco-bounces at maltedmedia.com] On Behalf Of Rietveld Rietveld
> Sent: Monday, July 10, 2017 11:58 PM
> To: Coco mailing list <coco at maltedmedia.com>
> Subject: [Coco] 3D printer
> 
> Just bought a 3D printer during Amazon's prime sale Now I need to figure out what to make when it comes Thursday
> 
> Sent from my BlackBerry Passport Red Edition.
> 
> --
> Coco mailing list
> Coco at maltedmedia.com
> https://pairlist5.pair.net/mailman/listinfo/coco
> 
> -- 
> Coco mailing list
> Coco at maltedmedia.com
> https://pairlist5.pair.net/mailman/listinfo/coco