[Coco] Creating and loading big machine code files into RSDOS

[William Astle]

You really do want to avoid loading over Extended Basic. Depending how 
far over it you go, it will crash. If you're careful, you can get away 
with a small amount of overlap but it gets fiddly doing that.

I did write a "paper" on loaders some years back which might be of use 
if you go that route. You can find it on my web site in the "Coco" 
section under "Projects". For ease in finding it, here's a direct link 
to the relevant page:

http://lost.l-w.ca/0x05/projects/coco-stuff/

In the PDF, there's an auto-executing example that loads any number of 
blocks of data from the same file as the main program which would mean 
you could have everything in a single file. There's also an example of 
how to do a two stage load that allows you to overwrite anything though 
that can get complicated.

On 2017-02-13 03:48 PM, Glen Hewlett wrote:
> Hi All,
>
> I’m currently using lwtools to assemble my transcoded z80 pacman to the 6809 and I’m getting close to the $E00-$7FFF range and I was wondering what are my options once my source code starts to go over the $8000 point and will start loading over Extended Color Basic and it will then fail loading won’t it?
>
> Is there an easy way that doesn’t require me to make my own disk loader program?  It would be amazing if such a feature was built in to lwasm.
>
> Currently I’m using Basic to load the ROMs and the character and sprite data in blocks of $2000 and moving them to other blocks of memory not needed during execution.  Then it loads the main program but when my code gets too big this is going to be a problem.
>
> If I do have to use a special loading program is there one that already exists that I can use for such a job?
>
> Thanks,
> Glen
>