[Coco] Glenside IDE + Multi-Pak + HDB-DOS

[RETRO Innovations]

On 9/11/2016 7:56 PM, Robert Gault wrote:
>
> Mark,
>
> Someone who owns the Glenside IDE and an MPI needs to determine which 
> unit or software fails with the IDE set to $FF7x. You should not 
> assume that the hardware forces use of $FF5x because it might be 
> possible to alter the READ routines in HDBDOS to compensate for the 
> "timing error" mentioned by Boisy.
>
> If the IDE controller is wired "badly" then you should expect both 
> READs and WRITEs to fail. Boisy in the source code mentions only READ 
> failures.
>
> Robert
Can someone point/link to the specific code section referencing the issue?

Jim