[Coco] rom swap with eprom?

[Mathieu Bouchard]

Le 2016-01-12 à 06:24:00, Steve C. a écrit :

> In the morning light, I can now see the ghost of 12 cartridge pins that
> have rubbed into either side of the 28-pin board through multiple uses. The
> 12v idea makes sense, didn't Tandy later remove that pin?
>
> So I'd want to tie the extra address pins low, to make the cartridge match
> the eprom burner's start location. (I hope.)

Apparently, the 12-volt pin only exists on the Coco 1 and the Multipak. If 
you want to use that pin on a Coco 2 or 3, you need to plug it in the 
Multipak.

  ______________________________________________________________________
| Mathieu BOUCHARD ----- téléphone : +1.514.383.3801 ----- Montréal, QC