[Coco] Coco Costing

[RETRO Innovations]

On 3/16/2015 10:30 PM, Michael Brant wrote:
> It seems it has been a while since this thread was discussed. But I have
> two questions.  Would this MPI be usable on just the CoCo3 or on early CoCo
> models?
It should work on both just fine, but if you wanted the higher addressed 
(ff80+), then it would need a new CPLD programmed.
> And did you come to a final estimate on the cost?
Not yet.  Board costs were lower than I anticipated, but I was waiting 
on a cart case to scope for measurements, do the final board render, and 
then get a final cost.