[Coco] 6 Chip 6809 Computer

[Bill Nobel]

Thx Ed, I looked around for a bit and decided this would be the best (and cheapest $42 US off ebay)  I noticed I might be able though, to switch the 27128 to a 29F256 EEPROM to get around UV erase, but still looking at timings and pin differences. (not very much pin difference)

Bill Nobel

> On Mar 3, 2015, at 11:03 PM, Edward Snider <zippster278 at gmail.com> wrote:
> 
> That's a great programmer Bill, you'll love it.  They will handle just
> about everything
> short of CPLDs and FPGAs with the right adapter.  Excellent choice.
> 
> - Ed
> 
> On Mar 3, 2015 10:55 PM, "Bill Nobel" wrote:
>> 
>> Hey Kip, question since I’ve now read most of your Wiki.  I ordered a
> TL866CS burner and  wanted to know do I burn the .hex file from Grant’s
> page? (haven’t burnt eproms since my early coco days. Project that I did
> was Coco controlled through cartridge rom & bitbanger)
>> 
>> I notice you have expanded this little unit a bit.  I was thinking of
> adding in the 68B21 that controls joystick and cassette back in for
> Drivewire.  Also bringing the 40 pin dock for the new SDC controller. I do
> like your Kipper bus idea though, as it kinda is similar to Kbus from Frank
> Hogg (Tc-9).
>> 
>> I’m like a little kid again and can’t wait for the stuff to be delivered
> to build it. I chose 6309 so I could at least bring 6809/6309 Level 1
> Nitros9 at some point.
>> 
>> Bill Nobel
>> 
> 
> -- 
> Coco mailing list
> Coco at maltedmedia.com
> https://pairlist5.pair.net/mailman/listinfo/coco