[Coco] DE-0 Nano Successfully Programmed!

[Steve Batson]

I'm assuming the board can be programmed without the RGB2VGA card attached...My DE-0 Nano should be her Friday. My plan is to program the board with Luis's code and have it ready to go when Kip's card arrives so I can test right away. Once tested and working, my next task will be to find an enclosure to put it in. 


On Jun 4, 2015, at 5:29 AM, Steve Batson <steve at batsonphotography.com> wrote:

> And that's what is expect if all is done right. 
> 
> Kip, I'd rather see your known working procedure than a translated procedure that had errors.
> 
> Steve Batson
> Batson Photography
> "Today's Special Moments, Tomorrow's Priceless Treasures"
> 
> Website: http://www.batsonphotography.com
> Blog: http://www.batsonphotography.com/blog
> Our Free Photography Site and Forum: http://www.digitalphotographerzone.com
> 
>> On Jun 4, 2015, at 4:39 AM, Steven Hirsch <snhirsch at gmail.com> wrote:
>> 
>>> On Wed, 3 Jun 2015, Steve Batson wrote:
>>> 
>>> This should be helpful. A little worrisome that there are so many errors that occur. If you have an additional tips from your experience, would be nice to see them too.
>> 
>> FWIW, I have yet to see any sort of error during either compilation or programming.
>> 
>> -- 
>> 
>> -- 
>> Coco mailing list
>> Coco at maltedmedia.com
>> https://pairlist5.pair.net/mailman/listinfo/coco
> 
> 
> -- 
> Coco mailing list
> Coco at maltedmedia.com
> https://pairlist5.pair.net/mailman/listinfo/coco