[Coco] DE0-Nano FPGA board - This is the one Luis used that Kip is making boards for, correct?

[Steve Batson]

Thanks Matt. It looked like Terasic was out of stock anyway. I went ahead and ordered from Digikey. Chances are, it will be here before the RGB2VGA card anyway, so if it takes a week or so, I'm not too worried about it.



On Jun 3, 2015, at 4:10 AM, Matthew Stock <stock at bexkat.com> wrote:

> Steve,
> 
> I'd personally buy through www.digikey.com.  If I recall, the shipping is
> quite high direct from Terasic (at least for their larger boards).  Digikey
> has a bit of a markup, but it's an overall better deal depending on the
> shipping to your location.
> 
> Terasic is the actual manufacturer of these boards.
> 
> Matt
> 
> 
> On Wed, Jun 3, 2015 at 12:36 AM, Steve Batson <steve at batsonphotography.com>
> wrote:
> 
>> I'm pretty sure this is the exact board Luis used, just want to make sure.
>> This is the best price I've seen. Sells for over $100 on Amazon. Not much
>> cheaper elsewhere.
>> 
>> $79 Here. About ready to order one and tinker with it until I get the
>> RGB2VGA board for it from Kip.
>> 
>> 
>> http://www.terasic.com.tw/cgi-bin/page/archive.pl?Language=English&CategoryNo=165&No=593&PartNo=1
>> 
>> 
>> 
>> 
>> --
>> Coco mailing list
>> Coco at maltedmedia.com
>> https://pairlist5.pair.net/mailman/listinfo/coco
>> 
> 
> -- 
> Coco mailing list
> Coco at maltedmedia.com
> https://pairlist5.pair.net/mailman/listinfo/coco