[Coco] CoCoSDC in a Dragon

[Marcelo Cannella]

Thank you very much Ed. As always very friendly and detailed your
information.

Cheers,
Marcelo

2015-07-19 16:02 GMT-03:00 Zippster <zippster278 at gmail.com>:

> Hi Marcelo,
>
> Yes, you set the jumper and switches as you read.
>
> You also need a modified DOSplus with the SDC commands integrated.
>
> You can find that, and instructions for flashing the SDC here…
>
> <http://www.6809.org.uk/tmp/da/dplus-sdc/ <
> http://www.6809.org.uk/tmp/da/dplus-sdc/>>
>
> It does work, I’ve used it.
>
> Here is a link to a zip on my google drive with a bunch of Dragon disk
> images I modified
> the header on to work with the SDC (.vdk files).
>
> <https://drive.google.com/open?id=0B1sgl615FlGnbU9abVJDaVRtMms <
> https://drive.google.com/open?id=0B1sgl615FlGnbU9abVJDaVRtMms>>
>
> - Ed
>
>
>
> > On Jul 19, 2015, at 1:30 PM, Marcelo Cannella <
> marcelo.cannella at gmail.com> wrote:
> >
> > Hello everyone. Is it possible to use a Dragon SDC CoCo 64 ?.
> > Reading the documentation I see the following:
> >
> > "Installing a jumper Between the center pin and the DRQ pin is required
> for
> > emulation of a Dragon DOS floppy controller ......
> > The DRGN switch selects the address scheme for the controller. In the OFF
> > position the controller will use the CoCo address scheme. In the ON
> > position, the controller will use the Dragon DOS address scheme. "
> >
> > Thank you very much.
> > greetings
> >
> > --
> > Coco mailing list
> > Coco at maltedmedia.com
> > https://pairlist5.pair.net/mailman/listinfo/coco
>
>
> --
> Coco mailing list
> Coco at maltedmedia.com
> https://pairlist5.pair.net/mailman/listinfo/coco
>