[Coco] 40 pin edge connectors

[Zippster]

This is for your new multi-pak design?

I compared the dimensions you linked for the 40-pin connector with a caliper
against the expansion bus connector and a couple of original Tandy paks
(drive controller & music synth).

They look good to me.  I also noticed you’ll need a minimum of ~25mm 
center to center between the slots for the above mentioned paks to fit next to
each other.

- Ed


> On Jan 19, 2015, at 9:14 PM, RETRO Innovations <go4retro at go4retro.com> wrote:
> 
> Can someone comment on these edge connectors and if they would work for a multi-pak?
> 
> http://s8.postimg.org/h0fvx7291/edge40.jpg
> 
> -- 
> RETRO Innovations, Contemporary Gear for Classic Systems
> www.go4retro.com
> store.go4retro.com
> 
> 
> -- 
> Coco mailing list
> Coco at maltedmedia.com
> https://pairlist5.pair.net/mailman/listinfo/coco