[Coco] Coco Cartridge Prototyping Pak PCB

[Kip Koon]

Hi Tim!
I had not thought of designing a smaller PCB, though I can.  I would think
as long as the Ground and VCC power rails on each edge of the PCB are not
shorted, trimming down the PCB should be fine.  I would also be happy to
make a smaller version.  The actual dimensions of this PCB is 152mm long
total, 98mm wide, with a useable length of 127mm minus edge connectors.  So
in inches, it would be 5.98" long total, 3.86" wide, with a useable length
of 5" minus the edge connectors.
I could relocate the decoding logic to allow it to be cut down smaller or
just design a much smaller version.  Exactly how small do you need?  

Kip Koon
computerdoc at sc.rr.com
http://www.cocopedia.com/wiki/index.php/Kip_Koon
http://computerpcdoc.com/


-----Original Message-----
From: Coco [mailto:coco-bounces at maltedmedia.com] On Behalf Of tim lindner
Sent: Friday, October 10, 2014 10:21 AM
To: 'Coco Email List'
Subject: Re: [Coco] Coco Cartridge Prototyping Pak PCB

Kip Koon <computerdoc at sc.rr.com> wrote:

> Here is the second version of the Coco Cartridge Prototyping Pak with 
> all your suggestions.

Kip,

Has there been any consideration to "after production" board modifications?

What I mean is cutting the board to a smaller size.

Is the board designed to safetly allow it to the trimmed down?


--
tim lindner
tlindner at macmess.org                                              Bright

--
Coco mailing list
Coco at maltedmedia.com
https://pairlist5.pair.net/mailman/listinfo/coco