[Coco] For sale? (Another SDC Case Attempt)

[Randy Kindig]

1 fully assembled 

Thanks!

Randy

Sent from my iPhone

> On Nov 7, 2014, at 10:38 AM, tim lindner <tlindner at macmess.org> wrote:
> 
> Thanks everyone for the kind words. I went and bought a bunch of
> scraps from tap plastic. Some clear, some translucent. For $14 I have
> the material to cut about 15 sets. For the clear plastic the engraved
> type is nice. But for translucent I would do a sticker as seen in my
> video.
> 
> So a complete set would be:
> 
> Top and bottom plate.
> 3 x 0.5 inch #6 machine screws
> 3 x 0.25 inch #6 machine screws
> 1 x stand off 5/8 inch tall, 0.25 OD
> 2 x stand off 1/8 inch tall, 0.25 OD
> 2 x stand off 9/16 inch tall, 0.25 OD
> 
> The stand offs might need some sanding down if the plastic is thicker than 3mm.
> 
> This would be the assembly instructions:
> 
> 1. The holes in the plates are all pilot holes, drill them all to size
> to fit the screws.
> 2. Using a 1/4 inch drill bit, flare the outside of each hole so the
> screw sits flush.
> 3. Attach the 5/8 inch tall stand off to the top plate in the center
> hole with a 1/4 inch screw.
> 4. Attach the 2, 9/16 inch tall stand offs to the top plate in the two
> end holes with 1/4 inch screws.
> 5. Attach the 2, 1/8 inch tall stands offs in the bottom plate in the
> two end holes with 1/2 inch screws.
> 6. Place the PCB on top of the bottom plate, aligning the two end holes.
> 7. Bring the top plate together with the bottom plate, aligning center
> stand off and the two end screws.
> 8. Screw the two end bottom plate screws to the two top plate stand offs.
> 9. Screw the center stand off to the bottom plate with a 1/2 inch screw.
> 
> So...
> 
> Would you want clear (like the pictures I posted yesterday) or
> translucent (like the video I posted this weekend)?
> How many would want completed cases, with plates and all the hardware,
> drilling and attaching?
> How many would want just the plates and hardware?
> How many would want just the plates?
> 
> Let me know and I'll work up some prices.
> 
> -- 
> --
> tim lindner
> 
> -- 
> Coco mailing list
> Coco at maltedmedia.com
> https://pairlist5.pair.net/mailman/listinfo/coco