[Coco] For sale? (Another SDC Case Attempt)

[Grumpyx]

I would be interested in 2 assembled, either is good.



On Fri, Nov 7, 2014 at 11:38 AM, Didier Derny <didier at aida.org> wrote:

> I would be interested in 2 fully assembled, clear.
>
>
> On 07/11/2014 16:38, tim lindner wrote:
>
>> Thanks everyone for the kind words. I went and bought a bunch of
>> scraps from tap plastic. Some clear, some translucent. For $14 I have
>> the material to cut about 15 sets. For the clear plastic the engraved
>> type is nice. But for translucent I would do a sticker as seen in my
>> video.
>>
>> So a complete set would be:
>>
>> Top and bottom plate.
>> 3 x 0.5 inch #6 machine screws
>> 3 x 0.25 inch #6 machine screws
>> 1 x stand off 5/8 inch tall, 0.25 OD
>> 2 x stand off 1/8 inch tall, 0.25 OD
>> 2 x stand off 9/16 inch tall, 0.25 OD
>>
>> The stand offs might need some sanding down if the plastic is thicker
>> than 3mm.
>>
>> This would be the assembly instructions:
>>
>> 1. The holes in the plates are all pilot holes, drill them all to size
>> to fit the screws.
>> 2. Using a 1/4 inch drill bit, flare the outside of each hole so the
>> screw sits flush.
>> 3. Attach the 5/8 inch tall stand off to the top plate in the center
>> hole with a 1/4 inch screw.
>> 4. Attach the 2, 9/16 inch tall stand offs to the top plate in the two
>> end holes with 1/4 inch screws.
>> 5. Attach the 2, 1/8 inch tall stands offs in the bottom plate in the
>> two end holes with 1/2 inch screws.
>> 6. Place the PCB on top of the bottom plate, aligning the two end holes.
>> 7. Bring the top plate together with the bottom plate, aligning center
>> stand off and the two end screws.
>> 8. Screw the two end bottom plate screws to the two top plate stand offs.
>> 9. Screw the center stand off to the bottom plate with a 1/2 inch screw.
>>
>> So...
>>
>> Would you want clear (like the pictures I posted yesterday) or
>> translucent (like the video I posted this weekend)?
>> How many would want completed cases, with plates and all the hardware,
>> drilling and attaching?
>> How many would want just the plates and hardware?
>> How many would want just the plates?
>>
>> Let me know and I'll work up some prices.
>>
>>
>
> --
> Coco mailing list
> Coco at maltedmedia.com
> https://pairlist5.pair.net/mailman/listinfo/coco
>