[Coco] VCC Experience

[Bill Nobel]

Hmm, I have to break out the Supercomm now (or was it OSterm?) To use Telnet now.

Bill Nobel
 
On May 25, 2014, at 5:43 PM, Aaron Wolfe <aawolfe at gmail.com> wrote:

> Yep, all of the /n devices have a "virtual modem" behind them that
> understands all of the standard Hayes AT commands.  This lets you use /n as
> a direct replacement for standard serial devices in any OS9 telecom
> programs (terminal emulators, BBSes, UUCP, etc have all been tested with
> good results).
> On May 25, 2014 7:40 PM, "Bill Nobel" <b_nobel at hotmail.com> wrote:
> 
>> Are you serious?  I never would of thought that, but thinking about it.
>> DW4 is a serial protocol on a virtual serial port.
>> 
>> Bill Nobel
>> 
>> On May 25, 2014, at 5:29 PM, Aaron Wolfe <aawolfe at gmail.com> wrote:
>> 
>>> On May 23, 2014 10:47 PM, "Bill Nobel" <b_nobel at hotmail.com> wrote:
>>>> 
>>>> Well, after a little makefile searching, I found what I needed.  I
>> played
>>> with telnet to my raspberry pi,  for a bit, works good except vt100 codes
>>> are coming through so ‘ls' breaks telnet with error 208.
>>> 
>>> Using a terminal emulator works better.
>>> 
>>> Supercomm is in the nitros9 project and works well.   Start it with /n as
>>> an argument, I.e.:  supercomm /n
>>> 
>>> Then use the DW Hayes AT commands to connect:  ATD1.2.3.4:5678
>>> 
>>> That way you'll get reasonable ansi/vt100 terminal emulation and a
>> channel
>>> where control codes won't cause issues.  Any terminal program should
>> work.
>>> 
>>> --
>>> Coco mailing list
>>> Coco at maltedmedia.com
>>> http://five.pairlist.net/mailman/listinfo/coco
>> 
>> 
>> --
>> Coco mailing list
>> Coco at maltedmedia.com
>> http://five.pairlist.net/mailman/listinfo/coco
>> 
> 
> -- 
> Coco mailing list
> Coco at maltedmedia.com
> http://five.pairlist.net/mailman/listinfo/coco