[Coco] Sacrificial carts - opinions?

[Kandur]

A perfect fit....:)
http://qdv.pw/eng/_photos/Computers/Coco/Coco_6068a-video-tape.jpg

Kandur

Sunday, June 8, 2014, 8:48:03 AM, you wrote:
> I strongly doubt that it would make economic
> sense to produce new injection-molded cartridge
> cases due to the tooling cost, but if I was
> stinkin' rich then I would do it just for fun.
> I've done plastic enclosure design at work and
> had them manufactured by ProtoMold. The tooling
> for a simple two-piece CoCo cartridge cases
> without the sliding cover would probably be
> around $10k. I don't think that the CoCo
> hobbyist market is large enough to absorb that
> cost. But it sure would be cool...
> -- 
> Mark J. Blair, NF6X <nf6x at nf6x.net>
> http://www.nf6x.net/