[Coco] CoCo 2 repair - Transformer?

[Al Hartman]

I would check the cartridge port schematic as I think there are voltages 
sent out to the cartridge port that need to be accounted for.

I can't be of more help with this as I'm not a hardware guy.

-[ Al ]-

-----Original Message----- 
From: camillus.b.58 at gmail.com
Sent: Wednesday, December 24, 2014 12:27 AM
To: CoCoList for Color Computer Enthusiasts
Subject: Re: [Coco] CoCo 2 repair - Transformer?

As far as I know the 12 volt is the output from the transformer after the 
bridge diode rectifier. Can be a bit more or less. Then all other voltages 
are derived from this 12V rectified source.


This being said, I’m not shure about the coco’s that had the old RAM who 
needed + and - 5v or 12 volt, but I was under the impression that only the 
coco I’s where such.


If your RAM chips work only on single voltage (5V) then you can even replace 
the transformer and power the coco with an 12 Volt DC 1.5 Amp. adapter. This 
needs a minor modification, which can also be undone as easy. But to explain 
this It would be better that you have a schematic of your board.


As for the capacitor, replace it, gives you ease of mind, the cost is not 
worth the ageny. And if it works with the capacitor you put in, with a 
little higher rating, just let it be. It would be close enough to  the 20% 
tollerance the capacitor has anyway.





Do you know what revision your board is?


Camillus


Sent from Surface





From: Chad H
Sent: ‎Tuesday‎, ‎December‎ ‎23‎, ‎2014 ‎7‎:‎48‎ ‎PM
To: CoCoList for Color Computer Enthusiasts





Actually I was going to consider that as an option "IF" I ever found a good 
service manual for the 26-3027/3127 models.  I know the unit needs both 
12V/5V power supplies but I don't know if 12V+/5V+ is sufficient or if there 
are required 12V-, 5V-, etc. rails.  Heck I don't even know where I would 
even tie into the main board such a external power supply.   If I did, and 
it was a simple 12V+/5V+/GND source I would tack on a molex connector and 
hook in a Pico ATX power supply :)

-----Original Message-----
From: Coco [mailto:coco-bounces at maltedmedia.com] On Behalf Of Louis Ciotti
Sent: Tuesday, December 23, 2014 7:25 PM
To: CoCoList for Color Computer Enthusiasts
Subject: Re: [Coco] CoCo 2 repair - Transformer?

Why are you looking at replacing the transformer, From your last posts it 
sould like you found the problem with a bad ground lead. If I were looking 
at doing anything with the CoCo power supply I would do a total gut and 
replace.  Been a while since I looked at it, but I seem to remember that it 
was not exactly the best power supply design, even for the time it was 
produced.

On Tue, Dec 23, 2014 at 8:11 PM, Michael Graham <mkgraham at gmx.com> wrote:

> Hi!
>
> I think you're looking at the specs on the transformer in the wrong way.
> You're measuring 10.8V on each side of the tap, but that wouldn't make
> it a 10.8V transformer, that would make it a 21.6V transformer.
>
> It probably is actually a 17.5V center-tapped transformer, but you're
> measuring 10.8V instead of 8.75V on either side of the tap because the
> CoCo isn't drawing the full amount of current for which the transformer is 
> rated.
>
> --Michael
>
>
>
> On 12/23/2014 6:52 PM, Chad H wrote:
>
>> In trying to identify potential replacement sources for power supply
>> parts I've yet to pin down one for the power transformer in my primary 
>> CoCo 2.
>> It
>> seems to be the same one in the 26-3027 as in the 26-3127 but there
>> is no label on the transformer itself.  The technical reference I
>> found for the
>> 26-3136 talks about a 17.5vac transformer but when I measured my
>> 26-3027 secondaries I got approximately 10.8vac on each point to
>> center.  I tested with the unit on and with it off, not much
>> difference.  I was wondering if the following might be a possible 
>> candidate.
>>
>>
>> http://tinyurl.com/lcwp2hp
>>
>>
>>
>>    Can someone tell me if I'm on the right track?  Thanks!
>>
>>
>> -          Chad
>>
>>
>>
>
> --
> Coco mailing list
> Coco at maltedmedia.com
> https://pairlist5.pair.net/mailman/listinfo/coco
>

--
Coco mailing list
Coco at maltedmedia.com
https://pairlist5.pair.net/mailman/listinfo/coco


-- 
Coco mailing list
Coco at maltedmedia.com
https://pairlist5.pair.net/mailman/listinfo/coco

-- 
Coco mailing list
Coco at maltedmedia.com
https://pairlist5.pair.net/mailman/listinfo/coco