[Coco] DriveWire is just a hobby (Was: DW4 on MAc & Linux)

[Arthur Flexser]

Al,

Well, since you indicated you were using ADOS (yay!), just use its
SCAN command and it will show start, end, and exec for a binary file:
SCAN"XYZ"

Art

On Thu, Sep 26, 2013 at 6:45 PM, Al Hartman <alhartman6 at optonline.net> wrote:
> DOH!!!!!
>
> Thanks Art!
>
> Do you know of a program that can look at a binary file and tell what
> address it is meant to load to?
>
> Because I don't know where the ROM files in the Drivewire image are going to
> load to.
>
> -[ Al ]-
>
> -----Original Message----- From: Arthur Flexser
> Sent: Thursday, September 26, 2013 4:24 PM
> To: CoCoList for Color Computer Enthusiasts
> Subject: Re: [Coco] DriveWire is just a hobby (Was: DW4 on MAc & Linux)
>
> Al, a trick I use to avoid having to calculate offsets is this:
>
> Say you want to move a file XYZ.BIN that would normally load at $7E00
> so that it loads at $2000 instead.  Just issue this command:
>
> LOADM"XYZ",&H2000-&H7E00
>
> Let the computer worry about the offset calculation!
>
> Art
>
> On Thu, Sep 26, 2013 at 4:02 PM, Al Hartman <alhartman6 at optonline.net>
> wrote:
>
>> I need to burn an HDB-DOS ROM for my J&M Controller. I just need to know
>> which file to use, and how to get it to the correct memory area so I can
>> burn it to an EPROM on my Coco. I'd like to burn one for the Coco 2, and
>> another for the Coco 3.
>>
>> All the Coco DECB manuals are cryptic on using the offset parameter of the
>> LOADM command, and I have to figure out where the ROM file is set to load
>> to, so I can calculate the offset and save it to tape for burning. I have
>> an
>> EPROM eraser coming in case I screw up. My old one has disappeared.
>>
>> ADOS made it seem so easy... LOL!
>>