[Coco] Attempting to upgrade a CoCo2

[Kip Koon]

Hi Mike!
Which version of the Coco 2 are you upgrading?  Do you have two 24 pin
rom/eprom IC sockets or one 28 pin rom/eprom socket?
Kip

-----Original Message-----
From: coco-bounces at maltedmedia.com [mailto:coco-bounces at maltedmedia.com] On
Behalf Of Mike Craig
Sent: Friday, October 04, 2013 9:55 PM
To: coco at maltedmedia.com
Subject: [Coco] Attempting to upgrade a CoCo2

Hi Everyone. I recently got my paws on a CoCo2 16k 26-3134. I'm going to
hunt down a 2716 Eprom and program it with ECB tomorrow. I'm lucky in the
fact that I have a surplus company around the corner from with with parts of
all kinds. Question I have is about the RAM upgrade. The eight RAM chips are
8040517's and from what I understand, I have to replace them with 4164 chips
of 200 ns or better access time, and to solder a wire between the two pads
labeled J1. I'm assuming that all eight chips need to match speed wise. I
did a search on Ebay and see lots of them listed. I have my eye on these
'NEC Dynamic RAM Memory 64K x 1-Bit UPD4164C-15'. Would those work? And am I
barking up the right tree so far? :D

Thanks,

Mike


--
Coco mailing list
Coco at maltedmedia.com
http://five.pairlist.net/mailman/listinfo/coco