[Coco] Drivewire 3 cabling problem

[Steven Hirsch]

On Sun, 29 Apr 2012, Chad H wrote:


> I'm working from the files & wiring schematic I keep here..

> http://www.mediafire.com/?2a0aitflana2v (For DriveWire)

>

> I noticed on the cabling diagram I have for DriveWire, it mentions all 4 

> connectors being used including a "Vcc".  However, on the pinout map, 

> There's no indication where Pin 1 should be connected to on the PC 

> Serial.


Not sure what that Vcc is about, but it's not required AFAIK.  My adapter 
uses only TX, RX and Gnd.

There's some trick to run higher baud rates that uses a different scheme, 
but don't worry about that until you have the basics working.

Steve



--