[Coco] Arduino question
afra at aurigae.demon.co.uk
Mon Oct 10 12:19:37 EDT 2011
On 10/10/2011 16:13, Mark Marlette wrote:
> Really depends on what you want to do.
> The STK500 is VERY reasonable. Look at all the target chips it
I have one though I have only really used it a couple of times, decent
enough dev board, but I found that it was much easier to make a
prototype of whatever I was trying to build than try to shoehorn a dev
board to connect to (for example) a CoCo/Dragon etc.
> Your link below to the mega1284, that is a HUGE chip, maybe you have
> a specific need for all of those features in that chip???
Or the fact that it has 16K of ram internally, quite usefull for disk
> BTW: The Atmel AVR would be a terrible approach to replace the
> SuperIDE. Seriously. Altera, better solution.
Agreed for IDE a CPLD/FPGA is the better solution.
But if you wanted to build an SD/MMC interface it works fine as most of
the AVRs have built in SPI to communicate with the SD, and can run
something like chan FATFS so that the SD card can be FAT formatted.
Loading a .cas file in 4 seconds as opposed to 4 minutes is pretty cool :)
Though to be fair I do have a XILINX 9572 acting as a databuffer,
address decoder / bus manager between the 6809 and the AVR.
More information about the Coco