[Coco] CoCo 3 to RBG...

[gene heskett]

On Monday, July 11, 2011 08:30:21 PM Steve Batson did opine:

> Thanks Gene...I will definitely be checking the specs when I get back
> home a little later.
> 
> As far as the cable, looking at the specs for the CoCo RGB connector and
> the 15 Pin VGA connector, I've matched up all the signals that both have
> that I would use to build the cable. Looking at it, I'm assuming I can
> tie the grounds together, ignore the Audio signal and the No Connection
> pins from the CoCo side. That being the case, the following table (I
> hope this comes through) should list everything I need to wire up the
> cable and get it working assuming I can use it with a monitor that
> supports the lower frequency range you described on the Horizontal
> Sync.
> 
> What do you think?
> 
> CoCo RGB
> 15 Pin RGB/VGA
> 
> 
> 
> 
> 1
> GND
> 5,6,7
> Ground
> 2
> GND
> 8,10
> Ground
> 3
> RED
> 1
> RED Out
> 4
> GREEN
> 2
> GREEN Out
> 5
> BLUE
> 3
> BLUE Out
> 6
> No Pin/No Connection
> N/A
> N/A
> 7
> AUDIO
> N/A
> N/A
> 8
> HSYNC
> 13
> HSYNC
> 9
> VSYNC
> 14
> VSYNC
> 10
> No Connection
> N/A
> N/A

This is pretty ambiguous, can you put it in two columns, using tab 
separators?

Cheers, gene
-- 
"There are four boxes to be used in defense of liberty:
 soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author)
Everything bows to success, even grammar.