[Coco] Dual UART with FIFO Card for the CoCo

[Mark Marlette]

The information given is correct. Mitel part. I bought a bunch and on the tail end of them. Not recommended for new design and really don't care for it. I used it because of the agreement I had with the author Dana Peters.

Cost for the CPLD to cross point is a wash and the CPLD has way more capabilities. Thus, use the old till gone and then switch to new platform.

Regards,

Mark
Cloud-9


----- Original Message -----
From: afra at aurigae.demon.co.uk
To: coco at maltedmedia.com
Sent: Wed, 16 Jun 2010 11:47:05 -0000 (UTC)
Subject: Re: [Coco] Dual UART with FIFO Card for the CoCo

Quoting Steven Hirsch <snhirsch at gmail.com>:


> On Wed, 16 Jun 2010, afra at aurigae.demon.co.uk wrote:

>

>> Quoting Mark Marlette <mmarlette at frontiernet.net>:

>>

>>> PS/2 Interface. I have a new design that requires the firmware to  

>>> be written. The design works, there are two. One uses the old  

>>> cross point switch and the new does the cross point in a CPLD.  

>>> Board supports both devices.

>>

>> Out of interest Mark, what crosspoint are you using ?

>

> The original PS/2 interface used a Mitel crosspoint switch, FWIW.


Humm, my design uses an MT8816, which is made by Zarlink, however the  
chip number belays the fact that I think it was prolly a Zarlink took  
over Mitel....

Cheers.

Phill.


----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.


--
Coco mailing list
Coco at maltedmedia.com
http://five.pairlist.net/mailman/listinfo/coco