[Coco] Weird CoCo3 problem...

[L. Curtis Boyle]

I had this problem way back with my Coco 1... And replacing the CPU  
fixed it for me. Hopefully, it's the same problem.

Sent from my iPhone
L. Curtis Boyle


On Jan 1, 2010, at 4:35 PM, Brian Blake <random_rodder at yahoo.com> wrote:

> Hi Arthur,
>
> Unfortunately, it's not socketed. Tho, I have about 9 6309's and  
> plenty of sockets... hmmmm.... maybe tomorrow....
>
>
>
> ________________________________
> From: Arthur Flexser <flexser at fiu.edu>
> To: CoCoList for Color Computer Enthusiasts <coco at maltedmedia.com>
> Sent: Fri, January 1, 2010 3:56:15 PM
> Subject: Re: [Coco] Weird CoCo3 problem...
>
> I vaguely recall something like this happening to me years ago that  
> was
> fixed by replacing the 6809.  If this machine and one of your others  
> has had
> the 6809 socketed, it would be easy enough to swap in a 6809 from  
> one of the
> other machines and see if the problem goes away.
>
> Art
>
> On 1/1/10, Brian Blake <random_rodder at yahoo.com> wrote:
>>
>>
>>
>> All of these new developments on the CoCo front finally lit the  
>> fire under
>> my arse to set up real hardware again. Besides my repack project, I  
>> have 3
>> other CoCo3's, two with 512k upgrades (one C9 and one PBJ) and one  
>> 128k. The
>> one with the C9 upgrade works fine - can load and play Sockmaster's  
>> Donkey
>> Kong.
>>
>> The one with the PBJ upgrade, not so... At boot, it comes up as it  
>> should
>> with the proper display. However, any floppy commands are met with no
>> response from the floppy drive (with an FD-502 controller) at all.  
>> Almost
>> like the drive is off. The drive responds as it should in the other  
>> two
>> machines. Upon removing the top case and k/b, I saw two wires, each  
>> had been
>> soldered to opposite sides of R23. Now, under the keyboard, is  
>> another wire
>> with alligator clips on each end, and the clips are holding on to  
>> the bare
>> end of the wires soldered to R23, effectively bypassing the  
>> resistor. I'm
>> looking for the PBJ instructions, pretty sure I have them, to find  
>> out if
>> this is called for. I can also see where C65 & C66 have been cut and
>> re-soldered. I have reseated the GIME and the PBJ memory chips, and  
>> cleaned
>> the 40 pin connector.
>>
>> Any other suggestions? My 100MHz o'scope bit the dust so I don't  
>> have that
>> tool any more (anybody have a CRT for a Leader 3 channel 100MHz  
>> scope??)
>>
>>
>> Thanks,
>>
>> Brian
>>
>>
>>
>>
>>
>> --
>> Coco mailing list
>> Coco at maltedmedia.com
>> http://five.pairlist.net/mailman/listinfo/coco
>>
>
> --
> Coco mailing list
> Coco at maltedmedia.com
> http://five.pairlist.net/mailman/listinfo/coco
>
>
>
>
>
> --
> Coco mailing list
> Coco at maltedmedia.com
> http://five.pairlist.net/mailman/listinfo/coco