robert.gault at worldnet.att.net
Tue Mar 17 18:19:56 EDT 2009
George Ramsower wrote:
> I use a "No Halt" DSC2 on the CNC machine. The address conflicts with
> the hard drive coco so it won't boot. The Hard drive coco uses a Ken Ton
> controller and requires a different address than what would be used on
> the CNC machine. So the boots are not compatible..... DARNIT!!
> Lemme investigate this a little more. Don't forget, this is OS9, not RS
> BASIC. So the drivers should work.
I think you just solved your problem. MESS does not know how to emulate
a no-halt controller. If your disk used a no-halt driver, it is not
likely to work with MESS.
More information about the Coco