[Coco] Regarding disk drives

[Darren A]

On 1/2/09, John Eric wrote:
> I wasn't too clear at the end of this. What I was meaning is if I jumper two
> drives as drive 1 and connect them to the IBM cables drive a and drive b
> connectors, that should give me drive 0 and 1 on coco and if I jumper a 3rd
> drive as drive 2 and connect it to the connector intended for a tape drive,
> that should work as coco drive 2. I'm going to go ahead and order the idc
> crimp tool as I realize it will have many uses, such as making a CM-8
> extender cable, etc.
>
> jeric

--

A standard PC floppy cable twists wires 10 through 16.  To use two
drives that are both jumpered as Drive 1 with a CoCo, you need a cable
that only twists wires 10 through 12.

Darren