[Coco] BLOB or something else?

[George Ramsower]

 This morning, I took the time to open up my CNC coco and get the controller 
out to actually put my eyes on the address selector jumper.
 Sure enough, it was in the wrong position. Then I remembered why. I used to 
have this controller in my other coco which has a SCSI hard drive in it and 
the SCSI controller did conflict with the Disto controller.
 During this nightmare of trying to get it to work, I did try the driver 
that uses the alternate address for the registers, but that didn't work 
either. I suppose it may have been because my bootlist order was not right 
when I did try it.

 Everyone was saying... "George, is the jumper correct?". But, I KNEW it 
was.... DOH!

 Oh, well. We live and learn.

George

----- Original Message ----- 
From: "George Ramsower"
Sent: Sunday, March 16, 2008 12:06 AM
Subject: [Coco] [coco] BLOB or something else?


> I've been threatening to create a new boot for my CNC coco to utilize the 
> Disto SCII disk controller, so finally I got a round tuit tonight.
>
> Now, I have not been able to get it to work.
>
> I expect the Boot List Order Bug, but can't confirm it.
>