[Coco] [coco] Coco CNC

[George Ramsower]

----- Original Message ----- 
From: "Gene Heskett"
> I probably need to reface my table too, its managed to collect a dig or 3 
> from
> errant end mills.  But first take up all the slack in the jibs, else it 
> will
> sag from its weight on the far end, and cut the end under the bit a thou 
> or
> so too much.
I would take those holes and drill and tap them to use later for clamps. Put 
set screws into them to keep the chips out until you need them.