[Coco] Using a Commodore 1084S with the CoCo

[Bob Devries]

Diego,
as far as I know, the intensity is only used if the monitor is used in its 
digital mode, not analog. I seem to remember that a straight through cable 
works fine. One of the other commodore monitor required composite sync, but 
I don't remember which thta was. I suspect it was the earlier one with the 
SCART socket.

My suggestion? Try it and see.

--
Regards, Bob Devries, Dalby, Queensland, Australia

Isaiah 50:4 The sovereign Lord has given me
the capacity to be his spokesman,
so that I know how to help the weary.

website: http://www.home.gil.com.au/~bdevasl
my blog: http://bdevries.invigorated.org/

----- Original Message ----- 
From: "Diego Barizo" <diegoba at adinet.com.uy>
To: "CoCo List" <coco at maltedmedia.com>
Sent: Wednesday, December 19, 2007 11:19 AM
Subject: [Coco] Using a Commodore 1084S with the CoCo


>I know that Cloud9 sells the cord, but for me right now, $20+SH could be 
>20.000 :-(
> That's why I would like to know if it's just a matter of making a pin to 
> pin cord.
>
> I found this as the monitor pinout:
>
> Pin   Digital Mode
> 1    Ground
> 2    Ground
> 3    Red
> 4    Green
> 5    Blue
> 6    Intensity
> 7    n/c
> 8    Horizontal Sync
> 9    Vertical Sync
>
> The CoCo has pin 6 as polarity(No pin) and audio on the 7.
> Would I have to do something fancy for the Intensity pin in the monitor?
>
> Thanks,
> Diego
>
>
> --
> Coco mailing list
> Coco at maltedmedia.com
> http://five.pairlist.net/mailman/listinfo/coco