[Coco] http://www.lcurtisboyle.com/nitros9/escape.html

[coco at yourdvd.net]

it allows specification of originate and execution addresses, and the
multiply origined files were the ones giving me difficulty, so that
explains it. i have emailed you a copy. i can't remember where i
downloaded it.

> -------- Original Message --------
> Subject: Re: [Coco] http://www.lcurtisboyle.com/nitros9/escape.html
> From: "L. Curtis Boyle" <curtisboyle at sasktel.net>
> Date: Fri, April 20, 2007 9:33 am
> To: CoCoList for Color Computer Enthusiasts <coco at maltedmedia.com>
> 
> On Fri, 20 Apr 2007 09:31:35 -0600,  wrote: > i believe it is
> freeware. it handles several cpu's, including the 6809. > you set the
> cpu via -c6809. I will email you a copy, it is relatively > small. Of
> course, you need to use a hex editor to remove a few bytes > from the
> beginning of the .bin file. When i use the software from mess > to
> extract the bin file, it adds something like 5 bytes or so to the >
> beginning, which i remove with a hexeditor and put the file back to >
> disk. then i execute the disassembler on it. It doesn't always seem to
> > be accurate, but i manage to get it to work good enough to get the
> job > done. It is DASMx. email enroute.... r Those 5 bytes would be
> the preamble, and there will be a 5 byte postamble as well. If the
> .BIN file is segmented, then you will have chunks like that in the
> middle, as well. Does the disassembler allow you to define data areas,
> ORG's of chunks of code? That would make handling these easier...
> otherwise, you may have to split the .BIN file into the pre-ambled
> chunks, and disassemble each separately. -- L. Curtis Boyle -- Coco
> mailing list Coco at maltedmedia.com
> http://five.pairlist.net/mailman/listinfo/coco