[Coco] Re: My coco3 gallery (Bob Devries)

[Stan Blazejewski]

Yep, that's the one. I seem to remember having the layouts as well but haven't
come across then in many years so I doubt if they're still around here any more.
I'd suspect there'd be a problem getting the WD2793 as I had a 'lot' of trouble
sourcing them the last few controllers I made maybe 10 years ago.

On Sat, 26 Aug 2006 15:26:52 +1000, you wrote:

>Thanks, Stan, I did find the schematic of Terry Thomas' design (which I 
>guess is the one you've got also).
>I'm sure I have a drawing of the two sides of the PCB somewhere, too.
>
>--
>Regards, Bob Devries, Dalby, Queensland, Australia
>
>Isaiah 50:4 The sovereign Lord has given me
>the capacity to be his spokesman,
>so that I know how to help the weary.
>
>website: http://www.home.gil.com.au/~bdevasl
>my blog: http://bdevries.invigorated.org/
>
>----- Original Message ----- 
>From: "Stan Blazejewski" <stanblaz at netspace.net.au>
>To: "CoCoList for Color Computer Enthusiasts" <coco at maltedmedia.com>
>Sent: Saturday, August 26, 2006 3:00 PM
>Subject: Re: [Coco] Re: My coco3 gallery (Bob Devries)
>
>
>If Bob doesn't have it, I still have the assembly manual/schematic of the 
>Ausy
>design 'mini' disk controller that Bob mentions in one of his other posts.
>It's a bit worst for wear (well used) but a high res scan should be 
>readable.
>
>On Fri, 25 Aug 2006 19:34:52 -0700, you wrote:
>
>> > Yeah, it still works. I was kinda surprised myself.
>> > I did use it with a disk drive (also home built) based on a 2793
>> > Western Digital controller.
>>
>>Mr. Devries,
>>
>>Would you happen to have the schematics for that controller? I don't
>>even know if the 2793 controller still exists or not, but I could use a
>>schematic of a "recent" disk controller.


--

Australia isn't "down under", it's "off to one side"!

stanblaz at netspace.net.au
www.cobracat.com (home of the Australian Cobra Catamaran)
http://groups.yahoo.com/group/cobra-cat/