[coco] advice needed

[RJRTTY at aol.com]

In a message dated 11/1/05 2:50:07 A.M. Eastern Standard Time,  
kevdig at hypersurf.com writes:

Do you have to change the hardware depending on whether you use an I2C  
command or just hold the line low? If you use a command then the jumper  
is not necessary. You just don't issue the  command.



Well,  there is no difference in hardware configuration between
the two.   Just different controller software.     The jumper would
only be needed if you hold the line low which is what I'm
doing here.
 
Roy