[Coco] Re: double disk drive

[sroussea at comlab.com]

Thank you very much Mr. Emery,

I will try it very soon.

Sylvain

On 5 Feb 2005, at 6:07, Robert Emery wrote:

> 
> > Yes, I want a switch to use either drive as drive 0 at any time.
> > 
> > I try Crystal City on drive 1 yesterday but it don't works. 
> > Crystal City works only on drive 0 (I think).
> > 
> > I see on the Bob's web page that it's possible to add a switch
> > to do this but I don't see how to do it.
> > 
> > May be Bob can help me?
> 
> So many messages... so little time...  :-)
> The way I did it was to intercept the two drive select lines for D0 and D1
> between the controller and the drives. These are pins 10 and 12 respectively.
> The red wire is number 1.
> 
> Carefully cut between wires to separate a couple of inches of these two wires
> (10 and 12). Now cut them and connect the controller-side of the wires to the
> two common poles of a DPDT switch. Now connect the drive-side of the wires to
> one pair of terminals on the switch, so that in one position the two lines go
> straight through. Next criss-cross the drive-side wires and connect to the
> other pair of switch terminals, so that when you toggle the switch, the Drive
> Select lines are swapped. That's all there is to it.
> 
> I did this specifically so I could boot from either 5.25" drive or 3.5" drive.
> Also incredibly useful is intercepting the Side-Select line (Pin 32) and run it
> to an inverter. Connect the inverted signal to N.O. and non-inverted signal to
> N.C. terminals of an SPDT toggle switch and then connect the common switch
> terminal to the drives (Pin 32). You CANNOT read the back of a FLIPPY by
> toggling the Side-select... you have to copy it over to DS FLOPPY before you
> can do that.
> 
> With the above two switches you can access (and boot from) either side of
> either floppy drive regardless of DOS, regardless of controller.
> 
> With regards to Color FOG requiring an FD502 controller, no it does not. It
> requires DECB 1.1 or HDB-DOS, which also requires DECB 1.1 as its foundation.
> ANY controller should work as long as it has the correct ROM version.
> 
> The DISK Basic ROM came in two versions AFAIK. 1.0 and 1.1. Even though the
> CoCo3 states Disk Extended Color Basic 1.2 (or whatever), this is not telling
> you the DISK ROM version. There are four different roms in the floppy equipped
> CoCo3... Color Basic, Extended Color Basic, Super Extended Color Basic and the
> Disk rom itself. Download Color FOG and run the installer, it will tell you if
> you have DECB 1.1 or not.
> 
> Good luck,
> Bob Emery
> 
> 
> 		
> __________________________________ 
> Do you Yahoo!? 
> Yahoo! Mail - Easier than ever with enhanced search. Learn more.
> http://info.mail.yahoo.com/mail_250
> 
> -- 
> Coco mailing list
> Coco at maltedmedia.com
> http://five.pairlist.net/mailman/listinfo/coco
>