[Coco] Re: Coco Digest, Vol 23, Issue 34

[L. Curtis Boyle]

    I never had problems with any of my hardware except the cassette port  
while running at 2MHz (32MHz clock crystal), although it did shift the  
screen over a bit. 2.25 was driving the video too much for my 8515  
monitor, and it blew, but the CM-8 handled it somewhat. Like I mentioned,  
my one machine still runs at 2 MHz, and I never had problems with disk  
access, etc.
    My TC-9 always ran at 2 MHz too, but it was fussier on floppy disk I/O  
timings (mind you, it was at stock speed, too). None of the hard drive  
systems I tried (B&B or Eliminator) had problems with it.

On Fri, 12 Aug 2005 16:35:55 -0600, <farna at att.net> wrote:


> The big problem with running a CoCo at higher than normal speeds is  

> timing for everything else, especially the GIME and disk access. I  

> programmed around that in the genealogy program I wrote by poking up at  

> the start of the program and poking down/up before/after every disk  

> access. There are some advantages to non-multi tasking systems! I don't  

> recall if the disk functiuon was fixed in the CoCo3 or there was a hack  

> for it, but do recall the GIME having problems over 2 MHz.

>

> --

> Frank Swygert

> Publisher, "American Independent

> Magazine" (AIM)

> For all AMC enthusiasts

> http://farna.home.att.net/AIM.html

> (free download available!)

> 			


L. Curtis Boyle