[Coco] ceramics ...
Paul T. Barton
idezilla at yahoo.com
Fri Sep 3 18:12:00 EDT 2004
Display shrunk in size (smaller pixels)
no other problems. The monitor sync did
need a touch on the knob, but not bad.
Display looked clean, no junk.
--- mmarlett at isd.net wrote:
> That would then point to a motherboard issue.
> I have done 10MHZ with wirewrap on a $500K
> digital tester. Results and not
> real good for repeatability. TONS of ringing
> due to reflections, mismatches
> and coupling. 40MHZ, lucky???
> What did your display look like??? Could you
> correct the monitor enough?
> >--- mmarlett at isd.net wrote:
> >> james,
> >> Common knowledge for most. Kind of like
> >> my Son that just because
> >> the RPM gauge runs in the RED doesn't mean
> >> engine will run forever
> >> there.
> >> The GIME, TCC1014A....Same thing here, sure
> >> can run it faster. I have
> >> modified the XTAL to 32MHZ for a true 2MHZ
> >> adjusted the internals of my
> >> monitor to compensate. My experience has
> >> that the GIME/motherboard or
> >> whatever becomes unstable. This is my
> >> experience. Roll them back
> >> and they work just fine. All my mod'd
> >> have all been returned to
> >> stock speeds due to reliability reasons.
> >> What overclocking have you done to the GIME
> >> what were your results?
> >> Please provide revision information, if
> >> relevant to your test cases.
> >> Mark
> >I've run my hand-wired cocozilla at 40MHz,
> >runs fine.
> >Paul Barton
> >Do you Yahoo!?
> >Win 1 of 4,000 free domain names from Yahoo!
> Enter now.
> >Coco mailing list
> >Coco at maltedmedia.com
> Coco mailing list
> Coco at maltedmedia.com
Do you Yahoo!?
Win 1 of 4,000 free domain names from Yahoo! Enter now.
More information about the Coco